CentOS Stream 9
Sponsored Link

GlusterFS 11 : GlusterFS Client2023/03/31
 
Configure GlusterFS Client to mount GlusterFS volumes.
[1] To mount with GlusterFS Native, Set like follows.
The example below shows to mount [vol_distributed] volume to [/mnt].
[root@client ~]#
dnf -y install centos-release-gluster11
[root@client ~]#
sed -i -e "s/enabled=1/enabled=0/g" /etc/yum.repos.d/CentOS-Gluster-11.repo
# enable EPEL, too

[root@client ~]#
dnf --enablerepo=centos-gluster11,epel -y install glusterfs glusterfs-fuse
# OK to specify any target nodes in cluster

[root@client ~]#
mount -t glusterfs node01.srv.world:/vol_distributed /mnt
[root@client ~]#
df -hT 

Filesystem                        Type            Size  Used Avail Use% Mounted on
devtmpfs                          devtmpfs        4.0M     0  4.0M   0% /dev
tmpfs                             tmpfs           2.0G     0  2.0G   0% /dev/shm
tmpfs                             tmpfs           784M  8.6M  775M   2% /run
/dev/mapper/cs-root               xfs              26G  2.3G   24G   9% /
/dev/vda1                         xfs            1014M  295M  720M  29% /boot
tmpfs                             tmpfs           392M     0  392M   0% /run/user/0
node01.srv.world:/vol_distributed fuse.glusterfs   52G  4.8G   48G  10% /mnt
# verify read and write

[root@client ~]#
echo "Gluster write test" > /mnt/testfile.txt

[root@client ~]#
cat /mnt/testfile.txt

Gluster write test
Matched Content