Windows 2019
Sponsored Link

NFS Server : Connection from NFS Client2019/04/10

 
This is How to connect to NFS Server from NFS Client.
[1]
Run PowerShell with Admin Privilege on the NFS Client that you set access permission to connect on NFS Server settings.
It's possbile to mount NFS Share with the command [C:\Windows\system32\mount.exe] that is installed by NFS Client installation, or also possible to use PowerShell Cmdlet [New-PSDrive] command.
On PowerShell by default, [mount] command is set Alias to [New-PSDrive] command, so if use [mount] command, specify full name of the filename [mount.exe].
Windows PowerShell
Copyright (C) Microsoft Corporation. All rights reserved.

# mount with [mount.exe] on Z drive
# syntax is the same with [mount] command on Linux
PS C:\Users\Administrator> mount.exe 10.0.0.101:/nfsshare Z:\ 
Z: is now successfully connected to 10.0.0.101:/nfsshare

The command completed successfully.

PS C:\Users\Administrator> Get-PSDrive Z 

Name           Used (GB)     Free (GB) Provider      Root                                               CurrentLocation
----           ---------     --------- --------      ----                                               ---------------
Z                  14.56         64.91 FileSystem    \\10.0.0.101\nfsshare

# unmount
PS C:\Users\Administrator> umount.exe Z:\ 

Disconnecting           Z:      \\10.0.0.101\nfsshare
The command completed successfully.

# mount with [New-PSDrive] on Z drive
PS C:\Users\Administrator> New-PSDrive -Name Z -PSProvider FileSystem -Root "\\10.0.0.101\nfsshare" 

Name           Used (GB)     Free (GB) Provider      Root                                               CurrentLocation
----           ---------     --------- --------      ----                                               ---------------
Z                                      FileSystem    \\10.0.0.101\nfsshare

# unmount
PS C:\Users\Administrator> Remove-PSDrive Z 
Matched Content