Windows 2016
Sponsored Link

iSCSI : Configure iSCSI Initiator (Server OS)2017/02/10

 
Configure iSCSI Initiator (Windows Server OS).
This example is based on the environment below.
    FD3S.srv.world     [10.0.0.100] - iSCSI Target
    RX-7.srv.world     [10.0.0.101] - iSCSI initiator
[1] Run Server Manager and Open [Tools] - [iSCSI Initiator].
[2] Click [Yes] button to proceed.
[3] Input Target's Hostname or IP address on [Target] field and click [Quick Connect] button.
[4] iSCSI Target has been detected like follows, click [Done] button.
[5] Click [Connect] button.
[6] Click [Advanced] button.
[7] Check a box [Enable CHAP log on] and specify username and password on the fileds. They are the just one you set on iSCSI Target's configuration.
[8] Click [OK] button.
[9] If it's no ploblem, the status turns to [Connected] like follows. It's OK to configure iSCSI initiator settings.
[10] On the [Disk Management] tool, the iSCSI Disk has been attached like follows.
[11] After changing online and initializing iSCSI disk, it's possible to use it like follows.
Matched Content