iSCSI : Configure iSCSI Initiator (Server OS)2017/01/20
Configure iSCSI Initiator (Windows Server OS).
This example is based on the environment below.
[10.0.0.100] - iSCSI Target
[10.0.0.101] - iSCSI initiator
|||Open [Control Panel] - [iSCSI Initiator].|
|||Click [Yes] button to proceed.|
|||Input Target's Hostname or IP address on [Target] field and click [Quick Connect] button.|
|||iSCSI Target has been detected like follows, click [Done] button.|
|||Click [Connect] button.|
|||Click [Advanced] button.|
|||Check a box [Enable CHAP log on] and specify username and password on the fileds. They are the just one you set on iSCSI Target's configuration.|
|||Click [OK] button.|
|||If it's no ploblem, the status turns to [Connected] like follows. It's OK to configure iSCSI initiator settings.|
|||On the [Disk Management] tool, the iSCSI Disk has been attached like follows.|
|||After changing online and initializing iSCSI disk, it's possible to use it like follows.|