Fedora 11
Sponsored Link

Configure Networking2009/06/10

[1] The settings of networking is DHCP by default. Change it to static one if you use the computer as a network server.
[root@dlp ~]#
vi /etc/sysconfig/network-scripts/ifcfg-eth0


# change

# name

DEVICE=eth0

HWADDR=00:0C:29:88:5C:40
ONBOOT=yes
# IP address for eth0

IPADDR=192.168.0.20
BOOTPROTO=static
# subnet mask

NETMASK=255.255.255.0
TYPE=Ethernet
# IP address of default gateway

GATEWAY=192.168.0.1
# IP address of DNS

DNS1=192.168.0.10
IPV6INIT=no
USERCTL=no
PREFIX=24
NAME="System eth0"


[root@dlp ~]#
/etc/rc.d/init.d/NetworkManager stop

Stopping NetworkManager daemon:
[  OK  ]

[root@dlp ~]#
/etc/rc.d/init.d/network restart

Shutting down interface eth0:
[  OK  ]

Shutting down loopback interface:
[  OK  ]

Bringing up loopback interface:
[  OK  ]

Bringing up interface eth0:
[  OK  ]

[root@dlp ~]#
chkconfig NetworkManager off

[root@dlp ~]#
chkconfig network on

[root@dlp ~]#
eth0
Link encap:Ethernet HWaddr 00:0C:29:88:5C:40

inet addr:192.168.0.20 Bcast:192.168.0.255 Mask:255.255.255.0

inet6 addr: fe80::20c:29ff:fe88:5c40/64 Scope:Link

UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1

RX packets:1534 errors:0 dropped:0 overruns:0 frame:0

TX packets:1469 errors:0 dropped:0 overruns:0 carrier:0

collisions:0 txqueuelen:1000

RX bytes:132650 (129.5 KiB) TX bytes:184685 (180.3 KiB)

Interrupt:17 Base address:0x1080


lo
Link encap:Local Loopback

inet addr:127.0.0.1 Mask:255.0.0.0

inet6 addr: ::1/128 Scope:Host

UP LOOPBACK RUNNING MTU:16436 Metric:1

RX packets:30 errors:0 dropped:0 overruns:0 frame:0

TX packets:30 errors:0 dropped:0 overruns:0 carrier:0

collisions:0 txqueuelen:0

RX bytes:3087 (3.0 KiB) TX bytes:3087 (3.0 KiB)

Matched Content