Configure iSCSI Initiator(Windows)2017/06/21
Configure iSCSI Initiator on Windows.
The example on here is on Windows Server 2012 R2.
( it's possible to configure on Windows 7/8/10 with the same procedure )
|||Open [Control Panel] - [iSCSI Initiator].|
|||Click [Yes] to proceed.|
|||Input iSCSI Target Server's Hostname or IP address in [Target] section and click [Quick Connect] button.|
|||iSCSI Target Server is detected, then click [Done] button.|
|||Click [Connect] button.|
|||Click [Advanced...] button.|
|||Check a box [Enable CHAP log on] and input username and password that you set in iSCSI Target Config in [Name] and [Target Secret] fileds, next click [OK] button, then back to the screen like , then click [OK] button again to proceed.|
|||After sucessing authentication, the status turned to [Connected] like follows. It's OK to use iSCSI storages.|
|||Open [Computer Management], then iSCSI storage has been attached.|