Initial Settings : Configure Services2023/06/14 |
To see services status or enable/disable services, Configure like follows.
|
|
[1] | Display services. |
# display services which are running # to add [--all], display all included inactive servises # to add [--no-pager], do not use pagers like [less/more] root@localhost:~# systemctl -t service UNIT apparmor.service blk-availability.service console-setup.service cron.service dbus.service ..... ..... systemd-user-sessions.service user-runtime-dir@0.service user@0.service LOAD = Reflects whether the unit definition was properly loaded. ACTIVE = The high-level unit activation state, i.e. generalization of SUB. SUB = The low-level unit activation state, values depend on unit type. 33 loaded units listed. Pass --all to see loaded but inactive units, too. To show all installed unit files use 'systemctl list-unit-files'. # display list of all services' setting root@localhost:~# systemctl list-unit-files -t service UNIT FILE STATE VENDOR PRESET apparmor.service enabled enabled apt-daily-upgrade.service static - apt-daily.service static - autovt@.service alias - blk-availability.service enabled enabled console-getty.service disabled disabled console-setup.service enabled enabled ..... ..... systemd-volatile-root.service static - udev.service alias - user-runtime-dir@.service static - user@.service static - x11-common.service masked enabled 117 unit files listed. |
[2] | If there are some unnecessary services, it's possible to Stop and turn OFF auto-start setting like follows. (possible to omit [.service] words) |
root@localhost:~# systemctl stop apparmor root@localhost:~# systemctl disable apparmor |
Sponsored Link |
|