NTPd : Configure NTP Server2014/07/08 |
|
Install NTPd and Configure NTP server for time adjustment.
|
|
| [1] | Install NTPd. |
|
[root@dlp ~]#
yum -y install ntp
[root@dlp ~]#
vi /etc/ntp.conf # line 18: add the network range you allow to receive requests restrict 10.0.0.0 mask 255.255.255.0 nomodify notrap # change servers for synchronization # server 0.centos.pool.ntp.org iburst# server 1.centos.pool.ntp.org iburst# server 2.centos.pool.ntp.org iburst# server 3.centos.pool.ntp.org iburst
server ntp1.jst.mfeed.ad.jp iburst
server ntp2.jst.mfeed.ad.jp iburst server ntp3.jst.mfeed.ad.jp iburst systemctl start ntpd [root@dlp ~]# systemctl enable ntpd |
| [2] | If Firewalld is running, allow NTP service. NTP uses 123/UDP. |
|
[root@dlp ~]# firewall-cmd --add-service=ntp --permanent success [root@dlp ~]# firewall-cmd --reload success |
| [3] | Verify it works normally like follows. |
|
[root@dlp ~]# ntpq -p
remote refid st t when poll reach delay offset jitter
==============================================================================
+ntp1.jst.mfeed. 172.29.1.100 2 u 29 64 1 18.826 -0.126 0.000
+ntp2.jst.mfeed. 172.29.2.50 2 u 28 64 1 21.592 0.018 0.000
*ntp3.jst.mfeed. 133.243.236.18 2 u 28 64 1 22.666 -1.033 0.000
|
| Sponsored Link |
|
|