CentOS 6
Sponsored Link

LVS + Keepalived #22013/08/20

 
It's Redundant configuration for LVS + Keepalived Server itself.
                              |
             +----------------+----------------+
             |                                 |
192.168.0.100|eth0 ----VIP:192.168.0.99--- eth0|192.168.0.101
     +----------------+               +----------------+
     | LVS+Keepalived |               | LVS+Keepalived |
     +----------------+               +----------------+
   10.0.0.100|eth1 -----VIP:10.0.0.99----- eth1|10.0.0.101
             |                                 |
             +----------------+----------------+
                              |
    +----------+              |               +----------+
    |          |10.0.0.30     |      10.0.0.31|          |
    | Backend1 |------------------------------| Backend2 |
    |   Web    | eth0                     eth0|    Web   |
    +----------+                              +----------+

 
Please change the default gateway to internal VIP address of Keepalived Server on both Backend Web Servers first. (it's 10.0.0.99 on this example)
[1] Clear the LVS settings first because it is controled by Keepalived.
[root@gw ~]#
ipvsadm -C

[root@gw ~]#
/etc/rc.d/init.d/ipvsadm save

ipvsadm: Saving IPVS table to /etc/sysconfig/ipvsadm: [ OK ]
[2] Configure Keepalived
It's OK to set the same settings except one setting on both backend servers. (it's "priority" section. Change it on both backend server.)
[root@gw ~]#
mv /etc/keepalived/keepalived.conf /etc/keepalived/keepalived.conf.bk

[root@gw ~]#
vi /etc/keepalived/keepalived.conf
# create new

global_defs {
    notification_email {
        cent@srv.world
    }
    notification_email_from root@srv.world
    smtp_server 127.0.0.1
    smtp_connect_timeout 30
    router_id LVS_Server
}
vrrp_instance VI_1 {
    state BACKUP
    interface eth0
    virtual_router_id 51
# priority (change it on both servers)

    priority 100
    advert_int 1
# authentication information between Keepalived servers

    authentication {
        auth_type PASS
        auth_pass password
    }

    virtual_ipaddress {
# virtual IP address

        192.168.0.99 dev eth0
        10.0.0.99 dev eth1
    }
}
virtual_server 192.168.0.99 80 {
    delay_loop 3
    lvs_sched rr
    lvs_method NAT
    protocol TCP

    real_server 10.0.0.30 80 {
        weight 1
        HTTP_GET {
            url {
                path /
                status_code 200
            }
            connect_timeout 3
        }
    }
    real_server 10.0.0.31 80 {
        weight 1
        HTTP_GET {
            url {
                path /
                status_code 200
            }
            connect_timeout 3
        }
    }
}

[root@gw ~]#
/etc/rc.d/init.d/keepalived restart

Stopping keepalived: [ OK ]
Starting keepalived: [ OK ]
[3]
It's OK all. Access to the Service IP address and make sure it works normally.
Matched Content