Configure FTP Server - Pure-FTPd2014/08/16

	Install Pure-FTPd to configure FTP Server.
[1]	Install Pure-FTPd.

# install from EPEL

[root@www ~]#

yum --enablerepo=epel -y install pure-ftpd

[root@www ~]#

vi /etc/pure-ftpd/pure-ftpd.conf

# line 77: change (no Anonymous)

NoAnonymous

yes

# line 143: uncomment

UnixAuthentication yes

# line 437: uncomment (if only IPv4)

IPV4Only yes

# line 443: uncomment (if only IPv6)

IPV6Only yes

[root@www ~]#

/etc/rc.d/init.d/pure-ftpd start

Starting proftpd: [ OK ]
[root@www ~]#

chkconfig pure-ftpd on

[2]	If IPTables is running, allow FTP port and fixed PASV ports. For "-I INPUT 5" section below, Replace it to your own environment.

[root@www ~]#

vi /etc/pure-ftpd/pure-ftpd.conf

# # line 180: uncomment and fix PASV ports

PassivePortRange

21000 21010

[root@www ~]#

/etc/rc.d/init.d/pure-ftpd restart

[root@www ~]#

iptables -I INPUT 5 -p tcp -m state --state NEW -m tcp --dport 21 -j ACCEPT

[root@www ~]#

iptables -I INPUT 5 -p tcp -m state --state NEW -m tcp --dport 21000:21010 -j ACCEPT

[3]	If SELinux is enabled, change bollean setting.

[root@www ~]#

setsebool -P allow_ftpd_full_access on

Matched Content